How to fit a dimmer switch

 

 

Fitting a dimmer switch may seem daunting but it needn't be. It involves switching off the power, isolating the circuit and knowing where each wire from your existing light switch should go when fitting your new dimmer switch. Follow our handy guide to successfully fit yours, step by step.

Step by step guide

1. Are you confident?

Can you complete the job confidently? Before you do anything, ask yourself this question.

Important Notice: Electricity can kill so it is of paramount importance that you know exactly what to do. If you're in any doubt, hire a professional to complete the job for you.

2. Switch off the power and isolate the electricity

Switch off the power on your consumer unit or fuse box and isolate the electricity on the circuit you'll be working on.

On consumer units, you can use a lock off device and padlock to ensure nobody will switch the power back on while you're fitting your new dimmer switch.

3. Unscrew your existing light switch

Use a screwdriver to remove your existing light switch from the back box on the wall.

It's important to make sure all wires are still left attached.

4. Check the circuit is dead

Check the circuit is dead by using a voltage tester. Use the probes to touch each of the terminals on the existing switch to check it's safe to work with. Tests should take place as follows....

- One probe touching the earth wire and the other probe touching the top terminal.

- One probe touching the earth wire and the other probe touching the bottom terminals.

- One probe touching the top terminal and the other probe touching the bottom terminals.

If no light illuminates on the voltage tester, the circuit is dead and it's safe to proceed.

5. Unscrew the wires (and mark them)

Use a screwdriver to remove the wires from the terminals on your existing light switch. The colour of the wires may vary but you must know where each should go on your new dimmer switch.

- Brown (or red) wire must go into C (Common)

- Grey wire must go into L2 (if black, it can go into L1 or L2)

- Black wire must go into L1 (or L2 if you have a red and black setup)

In some cases, marking them with some insulation tape or sleeving might help you distinguish them better.

6. Screw the wires into the correct terminals on your new dimmer switch

Use a screwdriver to attach the wires to the correct terminals on your new dimmer switch, following the correct wire locations outlined in step five.

Make sure all wires are firmly fixed before proceeding.

7. Screw your new dimmer switch to the back box on the wall

Now the wires have been successfully attached, use a screwdriver to screw your new dimmer switch to the back box on the wall.

8. Switch the power back on

Remove any locking device and/or padlock from your consumer unit and switch the circuit's electricity back on

9. Test your new dimmer switch

You've now successfully fitted your dimmer switch. Now the power is back on, test your dimmer switch by increasing and decreasing the brightness as you see fit.

Other important notes

  • Check the lamps on your circuit are dimmable
  • Ensure your back box is deep enough to house your new dimmer switch
  • Metal dimmer switch plates should never be fitted to a circuit that isn't earthed
  • When purchasing a dimmer switch, check its rating
  • Don't overwork the dimmer by purchasing the maximum wattage bulb allowed for the fixture

If you have any more questions or simply require further guidance, please call a member of our friendly team today on 01494 723 286. Our office hours are 08:30 to 17:00 from Monday to Friday.